How To Use

One 'n Only™ Argan Oil Hair Color Virgin Application, Tangerine Series

One ‘n Only™ Argan Oil Hair Color Virgin Application for hair that has not been previously colored.

Step 1
Follow the steps below for easy, predictable results
  • Determine the natural depth or level of the hair. Next, determine the percentage of gray.
  • Use the Natural or Gold series for maximum gray coverage results.
  • Determine the desired level and shade. Natural Series - rich neutral tones that provide maximum gray coverage; Ash Series - cool results to minimize warmth; Gold Series - soft, natural gold tones; Chocolate Series - rich chocolate results for brunettes; Tangerine Series - bright copper gold tones; Tobacco Series - rich golden tones for brunettes; Red Series - vibrant cool reds; Red Violet Series - rich cool reds; Copper Series - bright copper reds

Select the formula:

1 oz. 8RG
Light Blonde Tangerine
2 oz. 20 volume
One ’n Only™
Argan Oil Cream Developer

One 'n Only™ Argan Oil Permanent & Demi-Permanent Hair Color Chart

Color Chart

Use our hair color chart to help you determine color selection.

Mixing & Timing Chart

Timing Chart

Use our mixing and timing chart to help you determine the volume of developer, as well as usage and timing (without heat) needed for formula.

Step 2

Put on gloves

Step 3

Mix the formula: 1 part color with 2 parts developer

1 oz. 8RG Light Tangerine Blonde

2 oz. 20 volume One ’n Only™ Argan Oil Developer

Step 4

Section the hair into 4 parts

from ear to ear and down the center, all the way to the nape.

Reminder: It's important to look at the ends of the hair. If they're dry and porous, do not bring the color to that area right away. That could cause the ends to go off-tone or darker than the rest of the color.

Step 5

Begin applying the color

starting ½ -inch away from the scalp. Apply the color to the shaft of the hair (if the ends are porous, don't pull the color through). Continue to do this until all four sections are completed.

Reminder: It is important to understand the reason you don't start the application of color right at the scalp area. The heat from the body processes the color faster, so color would appear brighter at the root area than on the rest of the head.

Step 6

Set timer

Set timer for 15 minutes.

Step 7

Next,

apply the color to the scalp area in all four sections, taking ½ inch sub-sections until application to the entire head is completed.

Reminder: Set a timer for an additional 15 minutes to bring total processing time to 30 minutes. If you are covering gray, process for an additional 15 minutes, for a total of 45 minutes.

Step 8

Work the color through the hair on the mid-shaft, to make sure all hair is saturated with color.

Step 9

When the processing time is complete

rinse the color out with warm water. Shampoo and condition with One 'n Only™ Color Oasis or Argan Oil Shampoo and Conditioner.

Finished Look.
REMINDERS
  • For optimal results, always perform a skin patch test and strand test according to manufacturer's instructions prior to doing any hair color service.
  • Wait one to two weeks after a straightening or permanent service before applying One 'n Only™ Argan Oil Hair Color.