How To Use

  • >
  • Virgin Application (Hair that has not been previously colored)

One 'n Only™ Argan Oil Hair Color Virgin Application (for hair that has not been previously colored)

As we begin the color service, it's important to select a shade that will suit your skin and eye color. It is also important to stay within two levels of your natural hair color to minimize unwanted warm tones being exposed during the color service.
Step 1
Follow the steps below for easy, predictable results
  • Determine the natural depth or level of the hair. Next, determine the percentage of gray.
  • Use the Natural or Gold series for maximum gray coverage results.
  • Determine the desired level and shade. Natural Series - rich neutral tones that provide maximum gray coverage; Ash Series - cool results to minimize warmth; Gold Series - soft, natural gold tones; Chocolate Series - rich chocolate results for brunettes; Red Series - vibrant cool reds; Red Violet Series - rich cool red; Copper Series - bright coppper reds.

Select the formula:

1 oz. 4CH Medium
Chocolate Brown
1 oz. 6G Dark
Golden Blonde
4 oz. 20 volume
One ’n Only™
Argan Oil Cream Developer

One 'n Only™ Argan Oil Permanent & Demi-Permanent Hair Color Chart

Color Chart

Use our hair color chart to help you determine color selection.

Mixing & Timing Chart

Timing Chart

Use our mixing and timing chart to help you determine the volume of developer, as well as usage and timing (without heat) needed for formula.

Step 2

Put on Gloves

Step 3

Mix the Formula

1 part color with 2 parts developer

1 oz. 4CH Medium Chocolate Brown 1 oz. 6G Dark Golden Blonde 4 oz. 20 volume One ’n Only™ Argan Oil Cream Developer

Step 4

Section the hair into 4 parts

from ear to ear and down the center, all the way to the nape.

Reminder: It's important to look at the ends of the hair. If they're dry and porous, do not bring the color to that area right away. That could cause the ends to go off-tone or darker than the rest of the color.

Step 5

Begin applying the color

½ -inch from the scalp, and continue to the mid-shaft of the hair.

Reminder: It is important to understand the reason you don't start the application of color right at the scalp area. The heat from the body processes the color faster, so color would appear brighter at the root area than on the rest of the head.

Step 6

Continue working

around entire head until the application of color is complete. Set time for 15 minutes.

Step 7

Next,

in all four sections, taking ½-inch subsections until application to the entire head is completed.

Reminder: Set a timer for an additional 15 minutes to bring total processing time to 30 minutes. If you are covering gray, process for an additional
15 minutes, for a total of 45 minutes.

Step 8

Work the color through the hair

on the mid-shaft, to make sure all hair is saturated with color.

Step 9

When the processing time is complete

rinse the color out with warm water. Shampoo and condition with
One ’n Only™ Argan Oil Moisture Repair Shampoo and Conditioner.

Finished Look.
REMINDERS
  • For optimal results, always perform a skin patch test and strand test according to manufacturer's instructions prior to doing any hair color service.
  • Wait one to two weeks after a straightening or permanent service before applying One 'n Only™ Argan Oil Hair Color.